![]() ![]() Make sure the IP address you type in for HostName is the same as the one you saved on the CS2 screenħ. Highlight the CS2 and then click on PropertiesĦ. Your CS2 should be listed from your previous attemptĥ. Click on RocRail Prperties and navigate to the Controller tabĤ. Select the directory where your Rocrail file is locatedģ. Open RocRail and then click on Open WorkspaceĢ. Save this info by clicking the green checkmark.ġ. If not, enter the same address as the IP Gateway address.ĥ. Make sure that the DNS Server address has an address displayed. Write down the other 3 addresses displayed. On the IP page make sure you click on the Manually radio button instead of the DHCP buttonĤ. Click on the wrench to enter the configuration area. So here are the steps you need to follow:ġ. Oh, you do not need to connect the CS2 directly to the laptop, just to the network. The host name address of 10.0.0.11 looks strange to me. However, it does not appear that you have set up the Network IP addresses properly in RocRail. It sounds like you have identified the CS2 properly as the controller. File/RocRail Properties is grayed out.Īppreciate help in my attempt to get past step 1.Įdited by moderator 23 August 2021 07:05:31(UTC) I am unable to find this path and so believe I am not connecting Rocrail to the CS2. The comment is that this can be seen by following the link "Rocview → Programming →CBUS/MBUS". "If all went well, the CS3 is listed in the CBUS/MBUS dialog". Device is com1 and Baud rate defaulted to 50000. I also entered 15731 to the right of the Hostname. I don't see anything like a name CS3-06294. (This is what my CS2 shows as the IP address) Unlike the screenshot from the CS2.https. I entered the CS2 IP address 10.0.0.11 as Host name. Selected that entry and hit 'properties' and confirmed the Type is TCP. In the Property/controller view I entered MBUS in the box labeled New and hit 'enter'. Not sure if this means the CS2 has to be directly linked to the lap top or if I can connect through my network. Then "Note: Only direct TCP communication with the CS2/CS3 is supported in the Rocrail Forum.". Assume the instructions below still applied. This view is somewhat confusing as it states "The MCS2 library is replaced by the MBus library.". In RocRail, I go to File/RocRail Properties/Controller I loaded and opened RocRail for the first time and have tried to connect this to the CS2. I connected my CS2 to my home network via an RJ45 cable and entered the IP address into my laptop. I loaded RocRail onto my microsoft note book (windows 10) and am running into beginner issues. I currently run my layout from my CS2 but looking to see if I can and want to run from my laptop
0 Comments
Leave a Reply. |